Optical Audio Adaptor

Product Information

It also has to be implemented correctly so it's always running of battery. Many claim they do but in reality they really don't. Sinewave batteries can just produce stable clean power when done correctly, which is often very expensive. They could easily update both to support full bandwidth, all formats but it's all about HDCP, which is a shame. Also, maybe Toshiba invented the original digital toslink connected but both are S/PDIF, which was created by Sony and Philips.(see below).

The consumer version of the TOSLINK standard has stayed stable for decades. A TOSLINK optical audio cable from the 1990s will work just like one you buy today.Even fiber HDMI cables typically have 2 to 4 copper wires, which is why they are still shielded. Pretty sure toslink is no metal outside the connections, which are often plastic also. Noise is hard to pin down sometimes because it depends on your house/apartment wiring, potential ground loops, ECT...

And, in our experience, compared to optical, a coaxial connection does tend to sound better. That's because it has greater bandwidth available, meaning it can support higher quality audio up to 24-bit/192kHz. Optical is usually restricted to 96kHz. so assuming that the dac is equal in quality i would convert at the receiver. I could be mistaken, but my impression is that analog signals, especially unbalanced, low level signals, are susceptible to noise whereas digital signals, especially optical, are not. So you want to keep your analog signal path as short as possible. Might be I'm overthinking it all at the 'level' of equipment i have...so if you say 'just run what you have' I get it too... :)S/PDIF (Sony/Philips Digital Interface) is a type of digital audio interface used in consumer audio equipment to output audio over relatively short distances. The signal is transmitted over either a coaxial cable with RCA connectors or a fiber optic cable with TOSLINK connectors.

The answer to this will depend on the kit you’re using. If it’s a straight choice between coaxial and optical, we’d go for the former. In our experience, a coaxial connection tends to produce better audio quality than optical, allowing for a higher level of detail and greater dynamics. But don’t be tempted to try and use a standard RCA phono cable in place of a dedicated coaxial digital cable. They look similar and can work, but an analogue interconnect has different impedance values from a digital one (50 ohm versus 75 ohm), so won’t work as well. An entry-level cable like the QED Performance Coaxial will do a fine job for most. Also, think of your DAC as the source, not the player (transport) since the DAC is the source of the analog signal. So in this mindset keeping your source in close proximity still applies. Variations like in labeling are just that, "Digital Audio,""Optical Audio," and "Digital Audio (Optical)" all refer to the same standard. Are There Different Types of Optical Audio Connections and Cables?Pretty much this outside the fact that almost all HDMI cables shorter then 10 to 15ft max are copper. Really, you just need a well shielded cable although it's always a good idea to keep all cable runs as short as possible in my experience. The main downside to a coaxial digital connection is the potential transfer of electrical noise between your kit. Noise is bad news when it comes to sound quality, but it exists in all AV components to one degree or another. Unfortunately, using a coaxial connection enables noise to travel along the cable from the source to your amplifier. If better to use the panasonic dac, then should I go ordinary analogue interconnects, or the balanced pin cables? why?